1999-2003 TOYOTA SIENNA 4B KEYLESS ENTRY REMOTE TRANSMITTER GQ43VT14T

Obtain all remote transmitters for this vehicle. 1. Start with key out of the ignition, open and unlock drivers door and be sure all other doors and trunk are closed. 2. Insert key into ignition (Do not turn) and pull it out. 3. Perform these steps within 40 seconds. A. Using the power door lock rocker switch on drivers door perform 5 lock/unlock cycles starting with lock. Use an even pace and try to go about one cycle per second. (1 cycle = 1 lock and 1 unlock.). 4. Close, then open drivers door. 5. Perform these steps within 40 seconds. A. Using the power door lock rocker switch on drivers door perform 5 lock/unlock cycles starting with lock. Use an even pace and try to go about one cycle per second. (1 cycle = 1 lock and 1 unlock.) B. Insert the key in the ignition cylinder. C. Turn the ignition to ON (Just shy of starting car, Do NOT Start) then back to OFF. D. Turn the ignition to ON (Just shy of starting car, Do NOT Start)) then back to OFF. E. Remove the key from the ignition. 6. Within 3 seconds the power door locks should cycle automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point, if they do cycle then continue to step 7. 7. Perform these steps within 40 seconds. A. Press the lock and unlock buttons on the remote simultaneously for 1 second. B. Immediately after letting go of the lock and unlock buttons, Press the lock button by itself and hold for 2 seconds. Within 3 seconds the door locks should cycle once indicating successful programming. If the door locks don't cycle or cycle twice, repeat steps A and B, your remote has not been accepted. C. Repeat steps A and B in step 7 for each new transmitter. 8. Close drivers door. 9. Test all remotes.